Logging And Network Management Command Set
Configuring Node Aliases
Matrix DFE-Platinum and Diamond Series Configuration Guide 11-151
11.2.7.8 clear nodealias config
Use this command to reset node alias state to enabled and clear the maximum entries value.
clear nodealias config port-string
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset the node alias configuration on fe.1.3
:
port-string Specifies the port(s) on which to reset the node alias
configuration. For a detailed description of possible
port-string values, refer to Section 4.1.1.
Matrix(rw)->clear nodealias config fe.1.3
To Next Page
Loading...
