Port Configuration Command Set
Setting Flow Control
4-66 Matrix DFE-Platinum and Diamond Series Configuration Guide
4.3.7.2 set port flowcontrol
Use this command to enable or disable flow control settings for one or more ports.
set port flowcontrol port-string {receive | send | both}{enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable ports fe.3.1 through 5 to send and receive flow control packets:
port-string Specifies port(s) for which to enable or disable flow
control. For a detailed description of possible port-string
values, refer to Section 4.1.1.
receive | send |
both
Enables or disables the port(s) to receive, send, or receive
and send flow control packets.
enable | disable Enables or disables flow control settings.
Matrix(rw)->set port flowcontrol fe.3.1-5 both enable
To Next Page
Loading...
