SNMP Configuration Command Set
Configuring SNMP Access Rights
5-32 Matrix DFE-Platinum and Diamond Series Configuration Guide
5.3.3.3 clear snmp access
Use this command to clear the SNMP access entry of a specific group, including its set SNMP
security-model, and level of security.
clear snmp access groupname security-model {v1 | v2c | usm}
[noauthentication | authentication | privacy] [context context]
Syntax Description
Command Defaults
• If security level is not specified, all levels will be cleared.
• If context is not specified, none will be applied.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to clear SNMP version 3 access for the “mis-group” via the authentication
protocol:
groupname Specifies the name of the SNMP group for which to clear
access.
security-model v1 |
v2c | usm
Specifies the security model to be cleared for the SNMP
access group.
noauthentication |
authentication |
privacy
(Optional) Clears a specific security level for the SNMP
access group.
context context (Optional) Clears a specific context for the SNMP access
group. Enter / - / to clear the default context.
Matrix(rw)->clear snmp access mis-group security-model usm authentication
To Next Page
Loading...
Need help?
General