SNMP Configuration Command Set
Configuring SNMP Access Rights
Matrix DFE-Platinum and Diamond Series Configuration Guide 5-31
Command Defaults
• If security level is not specified, no authentication will be applied.
• If context is not specified, access will be enabled for the default context. If
context is specified without a context match, exact match will be applied.
• If read view is not specified none will be applied.
• If write view is not specified, none will be applied.
• If notify view is not specified, none will be applied.
• If storage type is not specified, entries will be stored as permanent and will be
held through device reboot.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example permits the “powergroup” to manage all MIBs via SNMPv3:
This example grants the “powergroup” SNMPv3 management access from all router modules when
operating in router mode:
Matrix(rw)->set snmp access powergroup security-model usm
Matrix(rw)->set snmp access powergroup security-model usm context router prefix
To Next Page
Loading...
