Security Configuration Command Set
Configuring Convergence End Points (CEP) Phone Detection
14-108 Matrix DFE-Platinum and Diamond Series Configuration Guide
14.3.8.6 set cep port
Use this command to enable or disable a CEP detection type on one or more ports.
set cep port port-string {cisco | h323 | siemens | sip} {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable Cisco phone detection on port fe. 3. 1
:
port-string Specifies the port(s) to enable or disable. For a detailed
description of possible port-string values, refer to
Section 4.1.1.
cisco Set the Cisco detection status on the specified ports.
h323 Set the H323 detection status on the specified ports.
siemens Set the Siemens detection status on the specified ports.
sip Set the SIP detection status on the specified ports.
enable | disable Enables or disables CEP detection as specified.
Matrix>set cep port fe.3.1 cisco enable
To Next Page
Loading...
