Port Configuration Command Set
Configuring Broadcast Suppression
Matrix DFE-Platinum and Diamond Series Configuration Guide 4-87
4.3.9.3 clear port broadcast
Use this command to reset the broadcast threshold and/or clear the peak rate and peak time values
on one or switch more ports.
clear port broadcast port-string [threshold] [peak]
Syntax Description
Command Defaults
If not specified, both threshold and peak settings will be cleared.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to clear all broadcast suppression settings on Fast Ethernet ports 1 through
5 in module1:
port-string Specifies the port(s) on which broadcast settings will be
cleared. For a detailed description of possible port-string
values, refer to Section 4.1.1.
threshold (Optional) Clears the broadcast threshold setting.
peak (Optional) Clears the broadcast peak rate and peak rate
time values.
Matrix(rw)->clear port broadcast fe.1.1-5
To Next Page
Loading...
