Enterasys Matrix 2G4072-52 - Reviewing and Configuring Routing Modules; Enabling the Switch for Routing

Preparing the Device for Router Mode
Reviewing and Configuring Routing Modules
2-162 Matrix DFE-Platinum and Diamond Series Configuration Guide
Figure 2-8 Enabling the Switch for Routing
2.3.2 Reviewing and Configuring Routing Modules
Purpose
To review and configure routing on one or two modules.
Commands
The commands used to review and configure routing modules are listed below and described in the
associated sections as shown.
• show router (Section 2.3.2.1)
• set router (Section 2.3.2.2)
• clear router (Section 2.3.2.3)
• router (Section 2.3.2.4)
Matrix(rw)->set router 1
Matrix(rw)->router 1
Matrix>Router1>enable
Matrix>Router1#configure terminal
Enter configuration commands:
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip address 182.127.63.1 255.255.255.0
Matrix>Router1(config-if(Vlan 1))#no shutdown