VLAN Configuration Command Set
Enabling/Disabling GVRP
7-44 Matrix DFE-Platinum and Diamond Series Configuration Guide
7.3.6.3 set gvrp
Use this command to enable or disable GVRP globally on the device or on one or more ports.
set gvrp {enable | disable} [port-string]
Syntax Description
Command Defaults
If port-string is not specified, GVRP will be disabled or enabled for all ports.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to enable GVRP globally on the device:
This example shows how to disable GVRP globally on the device:
This example shows how to enable GVRP on Fast Ethernet port 3 in module 1:
disable | enable Disables or enables GVRP on the device.
port-string (Optional) Disables or enables GVRP on specific port(s). For
a detailed description of possible port-string values, refer to
Section 4.1.1.
Matrix(rw)->set gvrp enable
Matrix(rw)->set gvrp disable
Matrix(rw)->set gvrp enable fe.1.3
To Next Page
Loading...
