Policy Classification Configuration Command Set
Configuring Policy Class of Service (CoS)
8-70 Matrix DFE-Platinum and Diamond Series Configuration Guide
8.3.3.8 set cos port-config txq
Use this command to set the Class of Service transmit queue port group configuration:
set cos port-config txq group-type-index [name name] [ports port-list] [append]
| [clear] [arb-slice slice-list] [arb-percentage percentage-list]
Syntax Description
Command Defaults
• If a name is not specified, default names described in Table 8-5 will be applied.
• If not specified, this configuration will be applied to all ports in the port group.
• If append or clear are not specified, port(s) will be appended to the specified
port grouping.
• If arb-slice or arb-percentage values are not specified, default allocations will
be applied.
Command Type
Switch command.
group-type-index Specifies a transmit queue port group/type index for this
entry. Valid entries are in the form of group.type. Group
can be 0-7, with 0 designating the default group, and 1-7
reserved for user-defined groups. Default port type values
cannot be changed, and are 0 for the Matrix
DFE-Platinum 7G4270-12 module, and 1 for all other
modules.
name name (Optional) Specifies a name for this configuration.
ports port-list (Optional) Applies this configuration to one or more ports
in the port group.
append | clear (Optional) Appends or clears port designations from a
previously configured port group.
arb-slice slice-list (Optional) The number of slices of transmit resources
allocated to each queue of a port. Input is in the format of
x0,x1,x2,...,xn.
arb-percentage
percentage-list
(Optional) The percentage of slices of transmit resources
allocated to each queue of a port. Input is in the format of
x0,x1,x2,...,xn.
To Next Page
Loading...
