Enterasys Matrix 2G4072-52 - Ip Pim Sparse Mode

IP Configuration Command Set
Configuring PIM
12-50 Matrix DFE-Platinum and Diamond Series Configuration Guide
12.2.7.1 ip pim sparse mode
Use this command to enable Protocol Independent Multicast (PIM) Sparse Mode (SM) on a routing
interface.
ip pim sparse-mode
Syntax Description
None.
Command Syntax of the “no” Form
The no form of this command disables PIM on an interface:
no ip pim sparse-mode
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Example
This example enables PIM sparse mode on VLAN 1:
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip pim sparse-mode