Enterasys Matrix 2G4072-52 - Clear Spantree Legacypathcost

Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
Matrix DFE-Platinum and Diamond Series Configuration Guide 6-57
6.2.1.44 clear spantree legacypathcost
Use this command to set the Spanning Tree default value for legacy path cost to 802.1t values.
clear spantree legacypathcost
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the default path cost values to 802.1t:
Matrix(rw)->clear spantree legacypathcost