Port Configuration Command Set
Setting Auto-Negotiation and Advertised Ability
4-52 Matrix DFE-Platinum and Diamond Series Configuration Guide
4.3.6.1 show port negotiation
Use this command to display the status of auto-negotiation for one or more ports.
show port negotiation [port-string]
Syntax Description
Command Defaults
If port-string is not specified, auto-negotiation status for all ports will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display auto-negotiation status for 1-Gigabit Ethernet port 14 in
module 3:
port-string (Optional) Displays auto-negotiation status for specific
port(s). For a detailed description of possible port-string
values, refer to Section 4.1.1.
Matrix(rw)->show port negotiation ge.3.14
auto-negotiation is enabled on port ge.3.14.
To Next Page
Loading...
