Enterasys Matrix 2G4072-52 - Show Vlanauthorization

Security Configuration Command Set
Configuring RFC 3580
Matrix DFE-Platinum and Diamond Series Configuration Guide 14-21
14.3.3.1 show vlanauthorization
Use this command to display the VLAN Authorization settings.
show vlanauthorization [port-list] | [all]
Syntax Description
Command Type
Switch command.
Command Mode
Read-Only.
Command Defaults
If no parameters are specified, all VLAN Authorization configuration information
will be displayed.
Example
This example shows how to display VLAN Authorization configuration information for ports
ge.1.1-3:
port-list (Optional) Displays the port(s) VLAN Authorization
settings.
all (Optional) Displays all port(s) VLAN Authorization
settings.
Matrix(su)->show vlanauthorization ge.1.1-3
VLAN Authorization Global Status: enabled
VLAN Authorization Table :
Port Status Admin Egress Oper Egress VLAN ID
--------------------------------------------------------------
ge.1.1 enabled untagged untagged 4094
ge.1.2 disabled untagged untagged none
ge.1.3 enabled untagged untagged unknown