Spanning Tree Configuration Command Set
Configuring Spanning Tree Port Parameters
Matrix DFE-Platinum and Diamond Series Configuration Guide 6-107
6.2.2.15 show spantree portcost
Use this command to display cost values assigned to one or more Spanning Tree ports.
show spantree portcost [port port-string] [sid sid]
Syntax Description
Command Defaults
• If port-string is not specified, port cost will be displayed for all Spanning Tree
ports.
• If sid is not specified, port cost will be displayed for all Spanning Trees.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the port cost for fe.2.5:
port port-string (Optional) Displays cost values for specific port(s). For a
detailed description of possible port-string values, refer to
Section 4.1.1
.
sid sid (Optional) Displays port cost for a specific Spanning Tree
identifier. Valid values are 0 - 4094. If not specified, SID
0 will be assumed.
Matrix(rw)->show spantree portcost port fe.2.5
Port fe.2.5 has a Port Path Cost of 2000000 on SID 0
To Next Page
Loading...
