General Configuration Command Set
Setting Basic Device Properties
Matrix DFE-Platinum and Diamond Series Configuration Guide 2-65
2.2.3.17 set summertime recurring
Use this command to configure recurring daylight savings time settings. These settings will start
and stop daylight savings time at the specified day of the month and hour each year and will not
have to be reset annually.
set summertime recurring start_week start_day start_month start_hr_min
end_week end_day end_month end_hr_min [offset_minutes]
Syntax Description
Command Defaults
If an offset is not specified, none will be applied.
Command Type
Switch command.
Command Mode
Read-Write.
start_week Specifies the week of the month to restart daylight
savings time. Valid values are: first, second, third,
fourth, and last.
start_day Specifies the day of the week to restart daylight savings
time.
start_hr_min Specifies the time of day to restart daylight savings time.
Format is hh:mm.
end_week Specifies the week of the month to end daylight savings
time.
end_day Specifies the day of the week to end daylight savings
time.
end_hr_min Specifies the time of day to end daylight savings time.
Format is hh:mm.
offset_minutes (Optional) Specifies the amount of time in minutes to
offset daylight savings time from the non-daylight
savings time system setting. Valid values are 1 - 1440.
To Next Page
Loading...
Need help?
General