Port Configuration Command Set
Setting Auto-Negotiation and Advertised Ability
Matrix DFE-Platinum and Diamond Series Configuration Guide 4-57
4.3.6.6 show port advertise
Use this command to display the advertised ability on one or more ports.
show port advertise [port-string]
Syntax Description
Command Defaults
If port-string is not specified, advertised ability for all ports will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display advertised ability fe.1.16:
Table 4-3 provides an explanation of the command output.
port-string (Optional) Displays advertised ability for specific port(s).
For a detailed description of possible port-string values,
refer to Section 4.1.1.
Matrix(rw)->show port advertise fe.1.16
fe.1.16 capability advertised remote
----------------------------------------------
10BASE-T yes yes no
10BASE-TFD yes yes no
100BASE-TX yes yes no
100BASE-TXFD yes yes no
1000BASE-X no no no
1000BASE-XFD no no no
1000BASE-T no no no
1000BASE-TFD no no no
other no no yes
pause yes yes no
Apause no no no
Spause no no no
Bpause no no no
To Next Page
Loading...
