Security Configuration Command Set
Configuring TACACS+
Matrix DFE-Platinum and Diamond Series Configuration Guide 14-37
14.3.4.11 show tacacs singleconnect
Use this command to display the current status of the TACACS+ client’s ability to send multiple
requests over a single TCP connection.
show tacacs singleconnect [state]
Syntax Description
Command Defaults
If state is not specified, all single connection configuration parameters are
displayed (which at this time includes only the enabled/disabled state).
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to display the state of the TACACS+ client’s ability to send multiple
requests over a single connection.
state (Optional) Specifies that only the single connection state
should be displayed.
Matrix(rw)->show tacacs singleconnect
TACACS+ single-connect state: enabled
To Next Page
Loading...
