IGMP Configuration Command Set
Configuring IGMP
Matrix DFE-Platinum and Diamond Series Configuration Guide 10-21
10.4.2.12 set igmp remove-static
Use this command to delete a static IGMP entry, or to remove one or more ports from an existing
entry.
set igmp remove-static group vlan-list [modify] [include-ports] [exclude-ports]
Syntax Description
Command Defaults
If not specified, the static entry will be removed and not modified.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to remove port fe.1.3 from the IGMP group at 224.0.2 (VLAN 105):
group Specifies a group IP address for the entry.
vlan-list Specifies the VLAN(s) on which to configure the entry.
modify Adds new ports to an existing entry.
include-ports Port or range of ports
exclude-ports Port or range of ports
Matrix(rw)->set igmp remove-static 224.0.0.2 105 modify
include-ports fe.1.3
To Next Page
Loading...
