Enterasys Matrix 2G4072-52 - Clear Snmp Targetparams

SNMP Configuration Command Set
Configuring SNMP Target Parameters
Matrix DFE-Platinum and Diamond Series Configuration Guide 5-45
5.3.5.3 clear snmp targetparams
Use this command to clear the SNMP target parameter configuration.
clear snmp targetparams targetParams
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to clear SNMP target parameters named “v1ExampleParams”:
targetParams Specifies the name of the parameter in the SNMP target
parameters table to be cleared.
Matrix(rw)->clear snmp targetparams v1ExampleParams