Logging And Network Management Command Set
Managing Switch Network Addresses and Routes
11-118 Matrix DFE-Platinum and Diamond Series Configuration Guide
11.2.5.15 set newaddrtraps
Use this command to enable or disable SNMP trap messaging, globally or on one or more ports,
when new source MAC addresses are detected.
set newaddrtrap [port-string] {enable | disable}
Syntax Description
Command Defaults
If port-string is not specified, MAC address traps will be globally enabled or
disabled.
Command Mode
Read-Write.
Example
This example shows how to globally enable MAC address traps:
port-string (Optional) Specifies the port(s) on which to enable or
disable MAC address traps. For a detailed description of
possible port-string values, refer to Section 4.1.1.
enable | disable Enables or disables SNMP trap messaging when new
source MAC addresses are detected.
Matrix(rw)->set newaddrtrap enable
To Next Page
Loading...
Need help?
General