General Configuration Command Set
Setting Basic Device Properties
2-44 Matrix DFE-Platinum and Diamond Series Configuration Guide
2.2.3.1 show ip address
Use this command to display the system IP address and subnet mask.
show ip address
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the system IP address and subnet mask:
Matrix(rw)->show ip address
Name Address Mask
---------------- ---------------- ----------------
host 10.42.13.20 255.255.0.0
To Next Page
Loading...
