General Configuration Command Set
Setting Basic Device Properties
2-50 Matrix DFE-Platinum and Diamond Series Configuration Guide
2.2.3.7 show system
Use this command to display system information, including contact information, power and fan tray
status and uptime.
show system
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display system information:
Table 2-6 provides an explanation of the command output.
Matrix(rw)->show system
System contact:
System location:
System name:
PS1-Status PS2-Status
------------- -------------
ok not installed
Fan1-Status
-------------
ok
Temp-Alarm Uptime d,h:m:s Logout
------------- -------------- -------------
off 0,19:40:00 10 min
PS1-Type PS2-Type
------------- -------------
6C207-1 not installed
To Next Page
Loading...
Need help?
General