General Configuration Command Set
Setting Basic Device Properties
Matrix DFE-Platinum and Diamond Series Configuration Guide 2-51
Table 2-6 show system Output Details
Output What It Displays...
System contact Contact person for the system. Default of a blank string can
be changed with the set system contact command
(Section 2.2.3.28).
System location Where the system is located. Default of a blank string can
be changed with the set system location command
(Section 2.2.3.27).
System name Name identifying the system. Default of a blank string can
be changed with the set system name command
(Section 2.2.3.26).
PS1 and
PS2-Status
Operational status for power supply 1 and, if installed,
power supply 2.
Fan Status Operational status of the fan tray.
Temp-Alarm Whether or not the system temperature alarm is off (within
normal temperature range) or on.
Uptime d,h:m:s System uptime.
Logout Time an idle console or Telnet CLI session will remain
connected before timing out. Default of 15 minutes can be
changed with the set logout command (Section 2.2.3.32).
PS1 and
PS2-Type
Model number of power supply 1 and, if installed, power
supply 2.
To Next Page
Loading...
Need help?
General