Policy Classification Configuration Command Set
Assigning Classification Rules to Policy Profiles
Matrix DFE-Platinum and Diamond Series Configuration Guide 8-43
8.3.2.7 set policy port
Use this command to assign an administrative rule to a port.
set policy port port-name admin-id
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to assign an administrative rule with an index of 20 to port fe.1.3:
NOTE: The set policy rule command (Section 8.3.2.4) used with the admin-profile
parameter will associate a classification rule with a policy profile index number, thus
making an administrative rule.
port-name Specifies the port(s) on which to set assign an
administrative rule. For a detailed description of possible
port-string values, refer to Section 4.1.1.
admin-id Specify a policy profile index number with a valid range of
[1..1023].
Matrix(rw)->set policy port fe.1.3 20
To Next Page
Loading...
