Logging And Network Management Command Set
Configuring Node Aliases
Matrix DFE-Platinum and Diamond Series Configuration Guide 11-139
11.2.7 Configuring Node Aliases
Purpose
To review, configure, disable and re-enable node (port) alias functionality, which determines what
network protocols are running on one or more ports.
Commands
Commands to configure node aliases are listed below and described in the associated section as
shown.
• show nodealias (Section 11.2.7.1)
• show nodealias mac (Section 11.2.7.2)
• show nodealias protocol (Section 11.2.7.3)
• show nodealias config (Section 11.2.7.4)
• set nodealias (Section 11.2.7.5)
• set nodealias maxentries (Section 11.2.7.6)
• clear nodealias (Section 11.2.7.7)
• clear nodealias config (Section 11.2.7.8)
To Next Page
Loading...
Need help?
General