Logging And Network Management Command Set
Configuring System Logging
11-10 Matrix DFE-Platinum and Diamond Series Configuration Guide
11.2.1.5 show logging default
Use this command to display the Syslog server default values.
show logging default
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This command shows how to display the Syslog server default values. For an explanation of the
command output, refer back to Table 11-1.
Matrix(rw)->show logging default
Facility Severity Port
-----------------------------------------
Defaults: local4 warning(5) 514
To Next Page
Loading...
