Security Configuration Command Set
Configuring Policy-Based Routing
Matrix DFE-Platinum and Diamond Series Configuration Guide 14-177
14.3.13.5 show ip policy
Use this command to display the policy applied to a routing interface.
show ip policy
Syntax Description
None.
Command Type
Router command.
Command Mode
Global configuration: Matrix>Router1(config)#
Command Defaults
None.
Example
This example shows how to display policy information:
Table 14-8 provides an explanation of the command output.
Matrix>Router1(config)#show ip policy
Interface Route map Priority Load policy Pinger Interval Retries
3 103 first first-available off 3 3
2 102 only round-robin on 10 4
Table 14-8 show ip policy Output Details
Output What It Displays...
Interface Routing interface.
Route map Route map assigned to the routing interface (using the ip
policy route-map command as described in
Section 14.3.13.6.)
Priority How the PBR next hop selection will be prioritized. Set with
the ip policy priority command as described in
Section 14.3.13.7.
Load policy How the PBR next hop will be selected. Set with the ip
policy load-policy command as described in
Section 14.3.13.7.
To Next Page
Loading...
Need help?
General