Configuring LACP
Configuring Link Aggregation
4-102 Matrix DFE-Platinum and Diamond Series Configuration Guide
4.5.4.2 set lacp
Use this command to disable or enable the Link Aggregation Control Protocol (LACP) on the
device. LACP is enabled by default.
set lacp {disable | enable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to disable LACP:
disable | enable Disables or enables LACP.
Matrix(rw)->set lacp disable
To Next Page
Loading...
