Port Configuration Command Set
Setting Console Port Properties
4-6 Matrix DFE-Platinum and Diamond Series Configuration Guide
4.3 PORT CONFIGURATION COMMAND SET
4.3.1 Setting Console Port Properties
Purpose
To review and set parameters for one or more of the device’s console ports, including baud rate, auto
baud detection, stopbits and parity.
Commands
The commands used to review and configure console port settings are listed below and described
in the associated section as shown.
• show console (Section 4.3.1.1)
• clear console (Section 4.3.1.2)
• show console baud (Section 4.3.1.3)
• set console baud (Section 4.3.1.4)
• clear console baud (Section 4.3.1.5)
• show console flowcontrol (Section 4.3.1.6)
• set console flowcontrol (Section 4.3.1.7)
• clear console flowcontrol (Section 4.3.1.8)
• show console bits (Section 4.3.1.9)
• set console bits (Section 4.3.1.10)
• clear console bits (Section 4.3.1.10)
• show console stopbits (Section 4.3.1.12)
• set console stopbits (Section 4.3.1.13)
• clear console stopbits (Section 4.3.1.14)
• show console parity (Section 4.3.1.15)
• set console parity (Section 4.3.1.16)
• clear console parity (Section 4.3.1.17)
To Next Page
Loading...
Need help?
General