Enterasys Matrix 2G4072-52 - Default Chapter; Show Lldp

Discovery Protocols Command Set
Link Layer Discovery Protocol and LLDP-MED
3-28 Matrix DFE-Platinum and Diamond Series Configuration Guide
3.2.4.1 show lldp
Use this command to display LLDP configuration information.
show lldp
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display LLDP configuration information.
Matrix(ro)->show lldp
Message Tx Interval : 30
Message Tx Hold Multiplier : 4
Notification Tx Interval : 5
MED Fast Start Count : 3
Tx-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
ge.5.1-12; tg.6.1-2; fe.7.1-48
Rx-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
ge.5.1-12;tg.6.1-2; fe.7.1-48
Trap-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
ge.5.1-12; tg.6.1-2; fe.7.1-48
MED Trap-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
ge.5.1-12;tg.6.1-2; fe.7.1-48