Enterasys Matrix 2G4072-52 - Reviewing IP Traffic and Configuring Routes

IP Configuration Command Set
Reviewing IP Traffic and Configuring Routes
12-34 Matrix DFE-Platinum and Diamond Series Configuration Guide
12.2.6 Reviewing IP Traffic and Configuring Routes
Purpose
To review IP protocol information about the device, to review IP traffic and configure routes, to
enable and send router ICMP (ping) messages, and to execute traceroute.
Commands
The commands used to review IP traffic and configure routes are listed below and described in the
associated section as shown:
• show router limits route-table (Section 12.2.6.1)
• set router limits route-table (Section 12.2.6.2)
• clear router limits route-table (Section 12.2.6.3)
• show ip protocols (Section 12.2.6.4)
• show ip traffic (Section 12.2.6.5)
• clear ip stats (Section 12.2.6.6)
• show ip route (Section 12.2.6.7)
• ip route (Section 12.2.6.8)
• ip icmp (Section 12.2.6.9)
• ping (Section 12.2.6.10)
• traceroute (Section 12.2.6.11)