Enterasys Matrix 2G4072-52 - Set Router Telnet

General Configuration Command Set
Starting and Configuring Telnet
Matrix DFE-Platinum and Diamond Series Configuration Guide 2-127
2.2.8.5 set router telnet
Use this command to enable or disable Telnet service to the router interface IP address.
set router telnet {enable | disable}
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to disable Telnet service to the router:
Matrix(rw)->set router telnet disable