General Configuration Command Set
Configuring Power over Ethernet (PoE)
Matrix DFE-Platinum and Diamond Series Configuration Guide 2-99
2.2.5.2 set inlinepower mode
Use this command to set the chassis power allocation mode.
set inlinepower mode {auto | manual}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the chassis power allocation mode to manual:
auto Assigns automatic mode to chassis power allocation.
manual Assigns manual mode to chassis power allocation. This setting
allows the values configured with the set inlinepower assigned
command (Section 2.2.5.8) to be applied to PoE modules.
Matrix(rw)->set inlinepower mode manual
To Next Page
Loading...
Need help?
General