Enterasys Matrix 2G4072-52 - Page 124

General Configuration Command Set
Configuring Power over Ethernet (PoE)
2-98 Matrix DFE-Platinum and Diamond Series Configuration Guide
Example
This example shows how to display device PoE properties. In this case, only the modules in slots 2
and 3 are PoE modules, so their power configurations display:
Matrix(rw)->show inlinepower
Total Power Detected : 1200 Watts
Total Power Available : 1200 Watts (100% of Total Power Detected)
Total Power Assigned : 0 Watts
Power Allocation Mode : auto
Power Trap Status : disabled
Power Redundancy Status : not redundant
Power Supply 1 Status : installed and operating
Power Supply 2 Status : not installed
Power Supply 3 Status : not installed
Power Supply 4 Status : not installed
Slot Oper Power Power Power Class Power Usage Usage PSE Mgmt
Status Limit Assigned Available Budget Usage Trhld Trap Mode
(W) (W) (W) (W) (W) (%) (%) Status
---- ------ ----- -------- --------- ------ ----- ----- ----- -------- --------
1 on 806 0 598 12 2 75 disabled class
2 on 806 0 599 5 1 75 disabled real-time
3 0
4 0
5 0
6 0
7 0