Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
Matrix DFE-Platinum and Diamond Series Configuration Guide 6-21
6.2.1.9 set spantree maxconfigurablestps
Use this command to set the maximum number of user configurable Spanning Tree instances.
set spantree maxconfigurablestps numstps
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the STP max configs to 8
numstps Specifies the maximum number of user configured STPs
to be allowed on this bridge.
Valid values are:
• 1 - 33 with 128 MB of memory installed (device
default), or
• 1 - 64 with an additional 128 MB memory upgrade.
Matrix(rw)->set spantree maxconfigurablestps 8
To Next Page
Loading...
Need help?
General