Routing Protocol Configuration Command Set
Configuring OSPF
Matrix DFE-Platinum and Diamond Series Configuration Guide 13-41
13.2.3.8 ip ospf transmit-delay
Use this command to set the amount of time required to transmit a link state update packet on an
interface.
ip ospf transmit-delay seconds
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command resets the retransmit interval value to the default,
1 second:
no ip ospf transmit-delay
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Example
This example shows how to set the time required to transmit a link state update packet on VLAN 1
at 20 seconds:
seconds Specifies the transmit delay in seconds. Valid values are
from 1 to 65535.
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip ospf transmit-delay 20
To Next Page
Loading...
