Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
6-76 Matrix DFE-Platinum and Diamond Series Configuration Guide
6.2.1.63 set spantree spanguardtrapenable
Use this command to enable or disable the sending of an SNMP trap message when span guard
detects that an unauthorized port has tried to join the Spanning Tree.
set spantree spanguardtrapenable {disable | enable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to disable the span guard trap function:
disable | enable Disables or enables the span guard trap function.
Matrix(rw)->set spantree spanguardtrapenable disable
To Next Page
Loading...
Need help?
General