Security Configuration Command Set
Configuring RADIUS
14-10 Matrix DFE-Platinum and Diamond Series Configuration Guide
14.3.2.1 show radius
Use this command to display the current RADIUS client/server configuration.
show radius [state | retries authtype || timeout | server [index | all]]
Syntax Description
Command Type
Switch command.
Command Mode
Read-Only.
Command Defaults
If no parameters are specified, all RADIUS configuration information will be
displayed.
Example
This example shows how to display RADIUS configuration information:
state (Optional) Displays the RADIUS client’s enable status.
retries (Optional) Displays the number of retry attempts before the
RADIUS server times out.
authtype (Optional) Displays the RADIUS server’s authentication
type.
server (Optional) Displays RADIUS server configuration
information.
timeout (Optional) Displays the maximum amount of time (in
seconds) to establish contact with the RADIUS server
before retry attempts begin.
index | all (Optional) Displays configuration information for a
specified server or all RADIUS servers.
Matrix(rw)->show radius
RADIUS state: Enabled
RADIUS retries: 2
RADIUS timeout: 3 seconds
RADIUS Server IP Address Auth-Port Realm-Type Status
---------- --------------- --------- ------------------ -------
1 100.10.0.100 1812 any Active
To Next Page
Loading...
