Enterasys Matrix 2G4072-52 - Show Port Ratelimit

Port Priority and Rate Limiting Configuration Command Set
Configuring Port Traffic Rate Limiting
9-16 Matrix DFE-Platinum and Diamond Series Configuration Guide
9.3.4.1 show port ratelimit
Use this command to show the traffic rate limiting configuration on one or more ports.
show port ratelimit [port-string]
Syntax Description
Command Defaults
If port-string is not specified, rate limiting information will be displayed for all
ports.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the current rate limiting information for fe.2.1:
port-string (Optional) Displays rate limiting information for specific
port(s). For a detailed description of possible port-string
values, refer to Section 4.1.1.
Matrix(rw)->show port ratelimit fe.2.1
Global Ratelimiting status is disabled.
Port Threshold Priority
Number Index (kB/s) Action Direction List Status
----------- ----- --------- ------------ --------- ----------- --------
fe.2.1 1 64 discard inbound 0 disabled
fe.2.1 2 64 discard inbound 0 disabled
fe.2.1 3 64 discard inbound 0 disabled
fe.2.1 4 64 discard inbound 0 disabled
fe.2.1 5 64 discard inbound 0 disabled
fe.2.1 6 64 discard inbound 0 disabled
fe.2.1 7 64 discard inbound 0 disabled
fe.2.1 8 64 discard inbound 0 disabled
fe.2.1 9 64 discard inbound 0 disabled
fe.2.1 10 64 discard inbound 0 disabled
fe.2.1 11 64 discard inbound 0 disabled
fe.2.1 12 64 discard inbound 0 disabled