Security Configuration Command Set
Configuring Multiple Authentication
Matrix DFE-Platinum and Diamond Series Configuration Guide 14-149
14.3.10.14show multiauth session-timeout
Use this command to display multiple authentication session-timeout values for an active session.
This will display the session-timeout values, in seconds, for the following authentication types:
dot1x, pwa, mac, and cep.
show multiauth session-timeout
Syntax Description
None
Command Type
Switch command.
Command Mode
Read-Only.
Command Defaults
None
Example
This example shows how to display multiple authentication session-timeout values, for an active
session:
Matrix(rw)->show multiauth session-timeout
Authentication type Timeout (sec)
------------------- -------------
dot1x 0
pwa 0
mac 0
cep 0
To Next Page
Loading...
Need help?
General