Enterasys Matrix 2G4072-52 - Set Cos Reference Irl

Policy Classification Configuration Command Set
Configuring Policy Class of Service (CoS)
Matrix DFE-Platinum and Diamond Series Configuration Guide 8-83
8.3.3.16 set cos reference irl
Use this command to set a Class of Service inbound rate limiting reference configuration.
set cos reference irl group-type-index reference rate-limit number
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to configure inbound rate limiting reference entry 0 for port group 0.1
referencing resources defined by IRL resource entry 0:
group-type-index Specifies an inbound rate limiting port group/type index
for this entry. Valid entries are in the form of group.type.
Group can be 0-7, with 0 designating the default group,
and 1-7 reserved for user-defined groups. Default port
type values cannot be changed, and are 0 for the Matrix
DFE-Platinum 7G4270-12 module, and 1 for all other
modules.
reference Specifies a reference number to be associated with this
entry.
rate-limit number Specifies a rate limiter resource ID to bind to this entry.
Matrix(rw)->set cos reference irl 0.1 0 rate-limit 0