Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
6-84 Matrix DFE-Platinum and Diamond Series Configuration Guide
6.2.1.71 show spantree newroottrapendable
Use this command to display the state of the Spanning Tree new root trap function.
show spantree newroottrapenable
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the status of the new root trap function:
Matrix(rw)->show spantree newroottrapenable
New Root Trap is set to enable
To Next Page
Loading...
