To Next Page

To Previous Page

General Configuration Command Set

Configuring Power over Ethernet (PoE)

Matrix DFE-Platinum and Diamond Series Configuration Guide 2-95

2.2.5 Configuring Power over Ethernet (PoE)

Purpose

To review and set PoE parameters, including the power available to the chassis, the usage threshold

for each module, whether or not SNMP trap messages will be sent when power status changes, and

per-port PoE settings.

Commands

The commands used to review and set PoE port parameters are listed below and described in the

associated section as shown.

• show inlinepower (Section 2.2.5.1)

• set inlinepower mode (Section 2.2.5.2)

• clear inlinepower mode (Section 2.2.5.3)

• set inlinepower available (Section 2.2.5.4)

• clear inlinepower available (Section 2.2.5.5)

• set inlinepower powertrap (Section 2.2.5.6)

• clear inlinepower powertrap (Section 2.2.5.7)

• set inlinepower assigned (Section 2.2.5.8)

• clear inlinepower assigned (Section 2.2.5.9)

• set inlinepower threshold (Section 2.2.5.10)

• clear inlinepower threshold (Section 2.2.5.11)

• set inlinepower management (Section 2.2.5.12)

• clear inlinepower management (Section 2.2.5.13)

• set inlinepower psetrap (Section 2.2.5.14)

• clear inlinepower psetrap (Section 2.2.5.15)

• show port inlinepower (Section 2.2.5.16)

Important Notice

This section applies only to PoE-equipped Matrix devices. Consult the Installation Guide shipped

with your product to determine if it is PoE-equipped.

Enterasys Matrix 2G4072-52 User Manual

Questions and Answers: