Matrix DFE-Platinum and Diamond Series Configuration Guide 13-1
13
Routing Protocol Configuration
This chapter describes the Routing Protocol Configuration set of commands and how to use them.
13.1 PROCESS OVERVIEW: ROUTING PROTOCOL CONFIGURATION
Use the following steps as a guide to configuring routing protocols on the device:
1. Activating advanced routing features (Section 13.2.1)
2. Configuring RIP (Section 13.2.2)
3. Configuring OSPF (Section 13.2.3)
4. Configuring DVMRP (Section 13.2.4)
5. Configuring IRDP (Section 13.2.5)
6. Configuring VRRP (Section 13.2.6)
ROUTER: The commands covered in this chapter can be executed only when the
device is in router mode. For details on how to enable router configuration modes, refer
to Section 2.3.3.
NOTE: The command prompts used in examples throughout this guide show a system
where module (or standalone device) 1 and VLAN 1 have been configured for routing.
The prompt changes depending on your current configuration mode, the specific
module, and the interface types and numbers configured for routing on your system.
To Next Page
Loading...
