General Configuration Command Set
Starting and Configuring Telnet
2-124 Matrix DFE-Platinum and Diamond Series Configuration Guide
2.2.8.2 set telnet
Use this command to enable or disable Telnet on the device.
set telnet {enable | disable}{inbound | outbound | all}
Syntax Description
Command Defaults
None.
Command Mode
Read-Write.
Example
This example shows how to disable inbound and outbound Telnet services:
enable | disable Enables or disables Telnet services.
inbound |
outbound | all
Specifies inbound service (the ability to Telnet to this
device), outbound service (the ability to Telnet to other
devices), or all (both inbound and outbound).
Matrix(rw)->set telnet disable all
Disconnect all telnet sessions and disable now (y/n)? [n]: y
All telnet sessions have been terminated, telnet is now disabled.
To Next Page
Loading...
