General Configuration Command Set
Starting and Configuring Telnet
Matrix DFE-Platinum and Diamond Series Configuration Guide 2-125
2.2.8.3 telnet
Use this command to start a Telnet connection to a remote host. The Matrix Series device allows a
total of four inbound and / or outbound Telnet session to run simultaneously.
telnet host [port]
Syntax Description
Command Defaults
If not specified, the default port number 23 will be used.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to start a Telnet session to a host at 10.21.42.13:
host Specifies the name or IP address of the remote host.
port (Optional) Specifies the server port number.
Matrix(rw)->telnet 10.21.42.13
To Next Page
Loading...
