Enterasys Matrix 2G4072-52 - Clear Spantree Hello

Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
Matrix DFE-Platinum and Diamond Series Configuration Guide 6-45
6.2.1.32 clear spantree hello
Use this command to reset the Spanning Tree hello time to the default value of 2 seconds.
clear spantree hello
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to globally reset the Spanning Tree hello time:
Matrix(rw)->clear spantree hello