Enterasys Matrix 2G4072-52 - Clear Spantree Maxhops

Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
6-66 Matrix DFE-Platinum and Diamond Series Configuration Guide
6.2.1.53 clear spantree maxhops
Use this command to reset the maximum hop count to the default value of 20.
clear spantree maxhops
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset the maximum hop count to 20:
Matrix(rw)->clear spantree maxhops