Policy Classification Configuration Command Set
Configuring Policy Class of Service (CoS)
8-88 Matrix DFE-Platinum and Diamond Series Configuration Guide
8.3.3.21 set cos settings
Use this command to configure a Class of Service entry.
set cos settings cos-list [priority priority] [tos-value tos-value] [txq-reference
txq-reference] [irl-reference irl-reference]
Syntax Description
Command Defaults
If no optional parameters are specified, none will be applied.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to create CoS entry 2 with a priority value of 3 and bind it to transmit
queue reference ID 5:
cos-list Specifies a Class of Service entry. Valid values are 0 -
255.
priority priority (Optional) Specifies a CoS priority value. Valid values are
0 - 7, with 0 being the lowest priority.
tos-value tos-value (Optional) Specifies a Type of Service value with mask in
the format of 0 - 255:0 - 255 or 0 - 0xFF:0 - 0xFF.
txq-reference
txq-reference
(Optional) Specifies the transmit queue associated with
this entry. Valid values are 0 - 15
irl-reference
irl-reference
(Optional) Specifies the inbound rate limiter associated
with this entry. Valid values are 0 - 31.
Matrix(rw)->set cos settings 2 priority 3 txq-reference 5
To Next Page
Loading...
