SNMP Configuration Command Set
Configuring SNMP Target Parameters
Matrix DFE-Platinum and Diamond Series Configuration Guide 5-39
5.3.5 Configuring SNMP Target Parameters
Purpose
To review and configure SNMP target parameters. This controls where and under what
circumstances SNMP notifications will be sent. A target parameter entry can be bound to a target
IP address allowed to receive SNMP notification messages with the set snmp targetaddr
command (Section 5.3.6.2)
Commands
The commands used to review and configure SNMP target parameters are listed below and
described in the associated section as shown.
• show snmp targetparams (Section 5.3.5.1)
• set snmp targetparams (Section 5.3.5.2)
• clear snmp targetparams (Section 5.3.5.3)
To Next Page
Loading...
Need help?
General